de Lisle Varitone Style Black 6 Position Number Plate
$10.00
- Specs
Replacement 6 position number plate in black for the de Lisle Pentatone or Gibson Varitone switches.
Related Products
-
de Lisle Notch Box Pedal
$189.00Designed with feedback from Justin Adams, guitarist for Robert Plant, the de Lisle Notch Box is based on the Gibson ® Varitone circuit found in guitars like the ES-355, Lucille and Blueshawk. Our pedal version offers 6 preset notch filters for various tones along with a potentiometer to control the notch depth. There is a voicing switch that allows you to toggle between the original '59 circuit and the redesigned Varitone introduced in the Blueshawk - that's 12 linearly variable filters in all!
The original Varitone was a simple passive device, so there was a fair amount of signal loss at higher settings. To counteract this, the Notch Box has an adjustable MOSFET boost. Set it to unity gain so your the effected and dry signals are at the same level.
The Notch Box was designed with other pedals in mind, so it has a high impedance input and a low impedance output. It will fit nicely at any position on your board.
The de Lisle Notch Box is hand-wired in the USA with silver plated 20AWG wire and no PCB mounted jacks, switches or plugs. This pedal is built to last and comes housed in a powder coated aluminum enclosure. As always with every piece of de Lisle gear, it's back by a lifetime warranty for your peace of mind.Maximum quantity exceededMinimum purchase amount of 0 is required -
￩￫
de Lisle Pentatone Switch
$45.00This is the same passive tone control that we use in our guitars. It's similar to the Gibson Varitone switch in function. We use a quality 6-position switch that features five frequency settings in addition to true bypass. Our design is vintage correct and a true notch filter. A "two wire" Varitone is not a proper notch filter. See the picture below for the difference in frequency response. The Pentatone switch comes pre-assembled and ready to install--just connect the the signal and ground wires. Purchase includes chicken-head knob, 6 number dial plate and the switch.
The switch diameter is 1.125". The depth under the mounting surface is about 1.175". The inductor is a .75" cube which is a attached to the switch with a couple inches of lead wire on either end.
See the specifications tab for notch frequncies.